Lazy-H98 Report post Posted July 2, 2019 So I was all set to seat my Accubonds for my 7MM, when I discovered a dent on the shoulder of several brass. First off what causes the shoulder dents? and is it still safe to shoot at the range? I noticed it on the first one and stopped right there. Share this post Link to post Share on other sites
oz31p Report post Posted July 2, 2019 Reloading is the only activity that too much lube causes a problem. 5 Share this post Link to post Share on other sites
10Turkeys Report post Posted July 2, 2019 Could be too much lube on your cases when you resize them, could be something is stuck in your die. That dent should blow out when you fire your gun. 1 Share this post Link to post Share on other sites
5guyshunting Report post Posted July 2, 2019 Too much lube and possibly dirty die. Share this post Link to post Share on other sites
muledeerarea33? Report post Posted July 2, 2019 I concur Share this post Link to post Share on other sites
10Turkeys Report post Posted July 3, 2019 Here ya go, get some of these, clean your dies with whatever your choice is, then cut down on your case lube and your dents should go away. Share this post Link to post Share on other sites
ctafoya Report post Posted July 3, 2019 I had a dirty die give me the same problem. Share this post Link to post Share on other sites
Lazy-H98 Report post Posted July 3, 2019 Thanks fellas! The vent hole was clear. Can hit is with some brake cleaner to help clean out my die? Share this post Link to post Share on other sites
5guyshunting Report post Posted July 3, 2019 1 hour ago, Lazy-H98 said: Thanks fellas! The vent hole was clear. Can hit is with some brake cleaner to help clean out my die? Thats what i use. Share this post Link to post Share on other sites
lancetkenyon Report post Posted July 3, 2019 What I use too. And a Q Tip. Share this post Link to post Share on other sites
Lazy-H98 Report post Posted July 3, 2019 Thank you! Share this post Link to post Share on other sites
Lazy-H98 Report post Posted July 3, 2019 2 hours ago, Lazy-H98 said: Thanks fellas! The vent hole was clear. Can hit is with some brake cleaner to help clean out my die? I fat fingered that one. Ment to say "Can I hit it with some brake cleaner to help clean out my die?" Thanks again fellas..... Share this post Link to post Share on other sites
PRDATR Report post Posted July 3, 2019 What lube are you using? A little Imperial Sizing Wax works great. The best was when Dillon came out with the spray in the aerosol can but they took it off the market after a few years. When they did I went to Hornady One Shot but it wasn't as good as the Dillon. Share this post Link to post Share on other sites
Lazy-H98 Report post Posted July 3, 2019 1 hour ago, PRDATR said: What lube are you using? A little Imperial Sizing Wax works great. The best was when Dillon came out with the spray in the aerosol can but they took it off the market after a few years. When they did I went to Hornady One Shot but it wasn't as good as the Dillon. Hornady One Shot can. Share this post Link to post Share on other sites
PRDATR Report post Posted July 3, 2019 1 hour ago, Lazy-H98 said: Hornady One Shot can. The wax is good stuff. Cases feel like it takes less effort to size them. Share this post Link to post Share on other sites
