Presmyk Report post Posted December 9, 2017 My buddy had a case split in 22-250 break open. The back blew off so how would get the stuck brass out? Share this post Link to post Share on other sites
HuntHarder Report post Posted December 9, 2017 I would try to bend down a piece just big enough to get some needle nose pliers on it. Share this post Link to post Share on other sites
Hoofnit Report post Posted December 9, 2017 this has happened to me, most times you can pull a brush thru from muzzle to breach and get them out. if that doesn't work take it to a gunsmith ! Mark Share this post Link to post Share on other sites
10Turkeys Report post Posted December 9, 2017 Headcase separation, as stated above an oversize brush through the breech past the case then pull it out. 1 Share this post Link to post Share on other sites
MMACFIVE Report post Posted December 10, 2017 If the above doesn't work you can find the right size tap and start a few threads in the brass then use a rod from the bore. Share this post Link to post Share on other sites
MMACFIVE Report post Posted December 10, 2017 If the above doesn't work you can find the right size tap and start a few threads in the brass then use a rod from the bore. 1 Share this post Link to post Share on other sites
Presmyk Report post Posted December 10, 2017 Was in chamber missing back about where a fl die stops and 8 just got it out with a easy out bit the tapered square bit you tap in and twist out Share this post Link to post Share on other sites
300RUM Report post Posted December 11, 2017 Before you try removing it soak it in a light penetrating oil. It will improve your chances of getting a brush or something else to pull it out. If the tricks mentioned above do not work they do make special broken case extractors that are not real expensive. I have them for .233 and .308 and have had good results 1 Share this post Link to post Share on other sites
