Opinions,

[MULEPACKHUNTER]

Thinking of putting chains on 2 spare tires for a late season hunt. Basically thought it would be easier to change wheel with chain on ready to go rather than put chains on???? Also planning on 2 fronts only ???? Don't plan on driving around for the hunt just having for emergency

[bigorange]

Makes sense if you already have the spares. Assuming when you need them youre not in the slop and unable to change out the whole thing for whatever reason.

[300RUM]

ATV / UTV ? Chains are usually pretty easy to install if the vehicle is jacked up and the tire is off the ground. You got to do that to change the tire anyway. If I were only going to run 2 Chains I would put them on the rear axle.

[trphyhntr]

probably be sunny and 65 degrees

[Tac]

chains are easier to install than a wheel/tire combo i would install chains when needed.

also the rear wheels are typically where chains would go.

make sure and have tighteners and stop after a mile of driving and recheck tension. Also carry a little mechanics or bailing wire and tie the ends of the chains to prevent them from hitting the body.

 

I had a late hunt 4 years or so ago near flagstaff and would have lost truck and trailer off the road if i didnt have chains. I ran them on all four wheels of the truck anytime i was not on asphalt and i was able to go anywhere i wanted. The same trip multiple guys slid off the road and damaged trucks and trailers. I ended up pulling a few out of the snow and ice

[Hoss50]

Jack the tire up off the ground and install the chains. That is the easiest way I have done it.

 

Fronts vs backs is up for debate. Some people want to make sure they can steer, some people want the traction of the rear tires.

 

The only times I have chained I have used all 4.

What size tires do you have? I have a full set of 4 chains you can borrow if you need them. They fit about 31-32" tires.

[300RUM]

If you're going to chain your truck cut a piece of 4 x 4 that will fit between the rails and crossbars of the chains when they're laid out flat and straight. Lay the chain out can place the four by four a few sections up from one end. Drive up on to the 4 x 4 then pull the long end of the chain up and over the top of the tire to connect to the other end. Tighten up the chain and drive off the 4 x 4. It's a trick we used to chain up tractor trailers.

[Tac]

watch the you tube videos of how to install made it easier but my neighbor who drives a semi was able to inform me of what to look out for.

[bigorange]

If you're going to chain your truck cut a piece of 4 x 4 that will fit between the rails and crossbars of the chains when they're laid out flat and straight. Lay the chain out can place the four by four a few sections up from one end. Drive up on to the 4 x 4 then pull the long end of the chain up and over the top of the tire to connect to the other end. Tighten up the chain and drive off the 4 x 4. It's a trick we used to chain up tractor trailers.

Good info right there. Very handy tip.

[MULEPACKHUNTER]

Ya the more I think I'm going to go with all 4 and just chain up if needed, going to grab a few for the trailer as well. Thanks for the info

Hoss , I'm in a stock ram 2500 275 85 18

[300RUM]

 

If you're going to chain your truck cut a piece of 4 x 4 that will fit between the rails and crossbars of the chains when they're laid out flat and straight. Lay the chain out can place the four by four a few sections up from one end. Drive up on to the 4 x 4 then pull the long end of the chain up and over the top of the tire to connect to the other end. Tighten up the chain and drive off the 4 x 4. It's a trick we used to chain up tractor trailers.

Good info right there. Very handy tip.

For anybody wanting to give it a try there is an advanced version of the technique where you drape the chain over the tire and then drive onto the block.

[Hoss50]

I sent you an email. I think they will fit. I sent you a message.

[thegunsmith2506]

As long as you have them, you wont need them.

[Hoss50]

What area is your hunt in?

[Edge]

Here's how I was taught; two chains, four wheel drive, place them on the front and rear wheels that have the power going to them. One front, one back and diagonal from one another is all I ever needed.