Cell4soul Report post Posted July 17, 2017 Anybody using this device for annealing or have any experience with it? http://www.annealeez.com/dbprod/annealeezannealer.asp Share this post Link to post Share on other sites
yotebuster Report post Posted July 17, 2017 Anybody using this device for annealing or have any experience with it? http://www.annealeez.com/dbprod/annealeezannealer.asp I was hesitant to click on that link!! 1 Share this post Link to post Share on other sites
wildwoody Report post Posted July 17, 2017 Sounds like a gay thing Share this post Link to post Share on other sites
Tac Report post Posted July 17, 2017 try salt annealing it seams to work pretty well Share this post Link to post Share on other sites
Zeke-BE Report post Posted July 17, 2017 Since Im a plumber I just set my torch up and leave it on full blast, hold the base of the brass with a light glove, and since I have mapp gas it burns lot hotter. So I twist it real quick for about 3 to 3-1/2 seconds at the shoulder and bam!!! Done! I can do a lot in a short amount of time. (by the way I use a torch on high heat on copper and brass all the time for work. I know when metals start to change so you might have to do a couple of practice rounds) I did this very quick! 2 Share this post Link to post Share on other sites
willhunt4coues Report post Posted July 18, 2017 I have one. I have had a few different more expensive models and sold all of them for this one. I anneal after every firing but don't anneal enough to justify the higher prices ones. Get it you will love it. Look at his face book page he sells tons of these. They are actually really well made. 1 Share this post Link to post Share on other sites
