ctafoya Report post Posted September 30, 2016 Anyone on here do dent removal in the East Valley? Share this post Link to post Share on other sites
TonyC Report post Posted October 2, 2016 Send me a picture. I can help you out most likely Share this post Link to post Share on other sites
ctafoya Report post Posted October 2, 2016 will do in the morning when i have light. Share this post Link to post Share on other sites
TonyC Report post Posted October 2, 2016 No problem. Have a good night. Share this post Link to post Share on other sites
ctafoya Report post Posted October 2, 2016 Not too worried about the scratches. Share this post Link to post Share on other sites
cjl2010 Report post Posted October 2, 2016 Flatbed!!! 3 Share this post Link to post Share on other sites
ctafoya Report post Posted October 2, 2016 If it wasn't a sissy 1/2 ton. 1 Share this post Link to post Share on other sites
cjl2010 Report post Posted October 2, 2016 Sounds like the dent can't be fixed and you have to sell it off for a 3/4 ton 1 Share this post Link to post Share on other sites
ctafoya Report post Posted October 2, 2016 Was gonna but chickened out. Too much negative equity. Maybe next year I can upgrade. Share this post Link to post Share on other sites
cjl2010 Report post Posted October 2, 2016 Good move. Nothing worse than continuing burying yourself in car loans Share this post Link to post Share on other sites
TonyC Report post Posted October 3, 2016 ahh that's not too bad at all. Hard location but... I can at least pull that dent out most the way. My only warning is since it's been dented; pulling the dent may cause the paint to chip/crack. (haven't seen it happen yet but there is always a chance it could) Either that or.. the hard way.. which consists of pulling the dent out, applying bondo to fill in the dented areas that's left and re-paint the area. (I can't paint for crap but I have a guy who does great work) Share this post Link to post Share on other sites
PRDATR Report post Posted October 3, 2016 Since it goes across a factory seam/bend it cant be popped out. Share this post Link to post Share on other sites
TonyC Report post Posted October 3, 2016 Since it goes across a factory seam/bend it cant be popped out. Pretty much, it makes it a challenge. Depending on how far the dent is, a lot of times as you pull the dent back out the seam will takes it place back. Or... a unique way is to drill a small hole on the back side and physically push it out and reshape it. (lots of work) Share this post Link to post Share on other sites
TonyC Report post Posted October 3, 2016 I had the same thing happen on the family minivan.. I was able to pull most of the dent out but a small indentation remains. 1 Share this post Link to post Share on other sites
