Tac Report post Posted August 28, 2016 I have never annealed before but have a point of impact change of about 1 Moa. Groups did not tighten at all they may have opened up a little. Do I need to redo my load? Share this post Link to post Share on other sites
lancetkenyon Report post Posted August 28, 2016 If you have not annealed before, you are changing neck tension. Going forward, if you continue to anneal, you will now have consistent neck tension. If your shooting conditions were anything like mine this morning, accuracy was a lot tougher to come by. 25+mph winds had me calling it quits after just two hours and only about 20 rounds total in 2 different rifles. Share this post Link to post Share on other sites
Tac Report post Posted August 28, 2016 I was at rio salado and had a crosswind yesterday afternoon testing jump n one gun and annealed brass on the other just noticed a poi change on my mag of 1 Moa at 200 part may have been the wind the groups were a little larger also. The other gun I was shooting and testing bullet jump and two different bullets and I learned it was good before I messed with it. Share this post Link to post Share on other sites
