Curtis Reed Report post Posted June 19, 2016 I picked up a used 686 6" revolver and noticed it has "push off" in single action. I would like a gunsmith to check it out and try to get it back to factory like trigger. Does anyone know of a good SMith revolver gunsmith? thanks Share this post Link to post Share on other sites
Couzer Report post Posted June 19, 2016 http://www.thegunsmith.com/thegunsmith.html Can be a little pricey, specializes in S&W. Share this post Link to post Share on other sites
Hoss50 Report post Posted June 19, 2016 Nelson ford. End of story for s&w. 1 Share this post Link to post Share on other sites
Hoofnit Report post Posted June 19, 2016 before you take it to a gunsmith remove the grips and make sure the strain screw at the bottom front is tight...some will loosen this to get a better double action pull, it needs to be tight or it can cause this. Mark Share this post Link to post Share on other sites
Curtis Reed Report post Posted June 19, 2016 thx hoofnit, just check it and she is snugged down tight Share this post Link to post Share on other sites
Hoofnit Report post Posted June 19, 2016 well it probably needs a new trigger & hammer...coulda had a bubba trigger job at some point... Share this post Link to post Share on other sites
firstcoueswas80 Report post Posted June 19, 2016 There's a guy in casa grande that is great, the gun Dr. Share this post Link to post Share on other sites
HuntHarder Report post Posted June 21, 2016 The link Vowell posted is the only guy you should even consider. Nelson Ford is pretty much a legend when it comes to S&W revolvers. Share this post Link to post Share on other sites
Curtis Reed Report post Posted June 23, 2016 thx guys. it was brought to Nelson and took care of it. thanks Share this post Link to post Share on other sites
