DesertBull Report post Posted October 13, 2014 Just curious as to what your step by step procedure is. Share this post Link to post Share on other sites
AZkiller Report post Posted October 13, 2014 Oal trim champfer, full length size, turn necks uniform primer pockets, uniform flash hole, DE Burr flash holes, clean, load, fire form. Share this post Link to post Share on other sites
AZkiller Report post Posted October 13, 2014 chamfer Share this post Link to post Share on other sites
10Turkeys Report post Posted October 13, 2014 Used to do all that, even index each piece of brass. Started using Lapua brass, no need for it now. 1 Share this post Link to post Share on other sites
pwrguy Report post Posted October 13, 2014 Played with it for a while, observed no noticeable improvement in group size. Share this post Link to post Share on other sites
Coues 'n' Sheep Report post Posted October 13, 2014 I have to turn necks on my 300 Wby brass... not so much on once shot but on multi shot brass it has a big affect on the POI of my Mark 5. Share this post Link to post Share on other sites
Hunterjohnny Report post Posted October 13, 2014 Chiropractors! 2 Share this post Link to post Share on other sites
WampusCat Report post Posted October 15, 2014 I find that turning necks, or just touching them up will reduce your Extreme Spread and Standard Deviation numbers. Normally that means less vertical in your groups and distance. I usually sort batches by neck thickness and then just barely trim enough off to make them uniform. I only remove the minimum amount needed. Doing this will help ensure consistant neck tension which is a big deal to me. Share this post Link to post Share on other sites
MULEPACKHUNTER Report post Posted October 15, 2014 I hit this pretty hard early on in reloading but I have not had the time to build a gun to suit it. I agree good brass negates some of the need and neck tension is very important. The most difference I ever saw was in SD which if I had the right rig would make a big difference at long range. I think AZkiller stole my checklist. Mr Zedyker I believe I have mentioned before has a book reloading for competition and if you want to learn about all the little tiny things that can move reloads around this book has it all from different presses to powder lots to neck turning. The biggest difference I ever saw was in primers and their effect on SD. These guys are making jagged holes at 800 yrds. Share this post Link to post Share on other sites
lancetkenyon Report post Posted October 15, 2014 This chic turns necks... 2 Share this post Link to post Share on other sites
firstcoueswas80 Report post Posted October 15, 2014 I didn't have a choice with my 7 LRM. Share this post Link to post Share on other sites
