DesertBull Report post Posted August 29, 2014 1-1/2" male DWV coupling fits on my Vortex Viper HD spotter perfectly. Female treadled coupling glued to camera makes the connection. Same exact principal as the Tinesup adapter. 7 Share this post Link to post Share on other sites
huntjunkie Report post Posted August 29, 2014 Nice! Share this post Link to post Share on other sites
rcdinaz Report post Posted August 29, 2014 Well done! Share this post Link to post Share on other sites
naturebob Report post Posted August 30, 2014 Lotta guys doing that. Nice little hook up. Good pics........BOB! Share this post Link to post Share on other sites
Big Browns Report post Posted August 30, 2014 Very Nice!!!!!! Share this post Link to post Share on other sites
Chris Report post Posted September 3, 2014 How does one keep the scope from moving, when you put that on the scope? Share this post Link to post Share on other sites
Hunterjohnny Report post Posted September 3, 2014 Nice DIY project. Well done. Share this post Link to post Share on other sites
DesertBull Report post Posted September 3, 2014 How does one keep the scope from moving, when you put that on the scope? It slides over the eyepiece of the scope very easily. Share this post Link to post Share on other sites
bonecollector Report post Posted September 3, 2014 Nicely done. Share this post Link to post Share on other sites
rossislider Report post Posted September 3, 2014 I need to give this a try. Share this post Link to post Share on other sites
HUNTnTAT2 Report post Posted September 3, 2014 Made one for my phone. 2" pvc plug. Cheap phone case. 3 screws. Had to put some felt on the inside of the plug to snuggly fit over my compact razor spotter Share this post Link to post Share on other sites
rossislider Report post Posted September 3, 2014 I have the same spotting scope, so I'm going to configure one for my camera phone using a second case that was given to me. While at Home Depot I noticed that there are a few different sizes of male couplings that could be screwed into the same female coupling. Might be able to make it work for my binos as well! Thanks for the idea! 1 Share this post Link to post Share on other sites
daryl_s Report post Posted October 4, 2014 What type of glue did you use? Share this post Link to post Share on other sites
rossislider Report post Posted October 4, 2014 I used hot glue for mine. Seems to hold well but is also fairly east to remove if I need to redo it. 1 Share this post Link to post Share on other sites
Guest wdenike Report post Posted October 4, 2014 Good idea!!!! Anytime you can save money= more money for family or TOYS!!!!! Take care, Willie Share this post Link to post Share on other sites
