seek100plus Report post Posted January 15, 2013 I have a set of Galley rings that where removed from my dads model 70 Winchester . I would like to get them back on there, they are marked 1 M and 2 M . I noticed it looks like the bases are slightly to different heights , 1 M mics at. 560 and 2 M at. 667 . I would also like to mount the same scope, a Zeiss 6.5x20x50. Would the 1 M or 2 M go in front or back. Thanks for any input would be great or should I call Talley Share this post Link to post Share on other sites
sjvcon Report post Posted January 27, 2013 Wished I could help you out, but I ditched my one piece Talley Rings from my M70, as I found that the rear scope ring had sheared on one side near the base. Seems they could not stand up to a .300 RUM on my Winchester. Rifle was never dropped, misused or mishandled in any way. Maybe I just got the bad set, but I was not going to repeat, so went with Warne Steel Rings instead. Share this post Link to post Share on other sites
azslim Report post Posted January 28, 2013 contact Talley Share this post Link to post Share on other sites
silencedmajority Report post Posted January 28, 2013 Did you notice if the different bases have different profiles to fit the receiver? I remember on my model 70 one piece Talley's, I got them switched up but noticed that they were machined differently to mate to the different parts of the receiver. Mine is a late model 70. Share this post Link to post Share on other sites
easttex Report post Posted January 29, 2013 Just call Talley. They are very good to deal with. Share this post Link to post Share on other sites
PRDATR Report post Posted January 29, 2013 Just curious. What did they have to say? Share this post Link to post Share on other sites
seek100plus Report post Posted January 29, 2013 I just spoke with Talley, it seems 2 is the rear ring and 1 is front ring , help me out a lot by 1 phone call Share this post Link to post Share on other sites
