rclouse79 Report post Posted January 8, 2010 A have a quick question. When I sighted in my bow and had to max out the gang adjustment by sliding the entire sight down as far as it would go, and I still had to move the 20 yd pin down even further for it to be on. I bought a 7 pin sight and I can only use the first 5 pins because I run out of room at the bottom of the sight. I think has to do with my peep sight placement, but I moved the peep so when I draw to my anchor point I open my eye and am naturally looking through the peep. It is not a big deal for this season because I don't plan on using more than my first 4 pins when hunting, but I would like to figure it out for the future. Any thoughts? Share this post Link to post Share on other sites
Garage Logic Report post Posted January 9, 2010 My buddy had the same problem with his Cobra Boomslang sight (which I also shoot).. I asked him to email a photo of the setup to me, and I noticed that the mounting bracket (arm that holds sight to riser) was installed incorrectly. He had it flipped upside down. After I pointed out that it was upside down, he corrected it, and it solved the problem. Make sure it is installed correctly. I'm sure your anchor and peep are fine. Share this post Link to post Share on other sites
