Ed67 Report post Posted May 5, 2024 Last week I had an impeller pump failure at Alamo. Likely the impeller came apart before I even went out there. At the lake it wasn’t peeing water at neutral or in gear. I replaced the impeller and pump housing because the impeller melted and clogged the discharge tube. Now the motor pees water at neutral but in gear at idle/accelerate it does not. Any thoughts? Thermostat or other? Anyone ever have similar issues? TIA Share this post Link to post Share on other sites
Toad Report post Posted May 9, 2024 It could be possible that while running it in a tank, the exhaust bubbles are interfering with water pick up when increasing the throttle. Might be worth taking to the lake like it is for test run Share this post Link to post Share on other sites
Ed67 Report post Posted May 9, 2024 I figured it out after removing and replacing about 5 times. . I was missing the rubber gasket in the pump housing. Once I replaced it the pressure was great. 1 Share this post Link to post Share on other sites
