bowhunter-tw Report post Posted September 10, 2023 Ive got a howa 223 with too thin of a profile to thread. Considering rebarreling with a prefit. Looking for someone who might have the equipment to help me Share this post Link to post Share on other sites
MULEPACKHUNTER Report post Posted September 10, 2023 i have a vise i can sell, 400.00 1 Share this post Link to post Share on other sites
bowhunter-tw Report post Posted September 11, 2023 3 hours ago, MULEPACKHUNTER said: i have a vise i can sell, 400.00 I think i’ll go the midway or brownells route. That one looks nice but a little pricey for me Share this post Link to post Share on other sites
MULEPACKHUNTER Report post Posted September 12, 2023 IF YOU BUY THE ACTION SIDE ILL SWAP IT AND KEEP THE WRENCH????? WRENCH = 50.00 PLUS SHIPPING Granted Howa is known to be the worst factory removal known to gunsmiths 1 Share this post Link to post Share on other sites
Hoss50 Report post Posted September 17, 2023 Howa barrels are really hard to get off normally from what I hear. When Axisworks did mine they told me before hand that they would likely have to relief cut it to get it off, and they did. Share this post Link to post Share on other sites
bowhunter-tw Report post Posted September 17, 2023 23 minutes ago, Hoss50 said: Howa barrels are really hard to get off normally from what I hear. When Axisworks did mine they told me before hand that they would likely have to relief cut it to get it off, and they did. Ive heard the same Share this post Link to post Share on other sites
bowhunter-tw Report post Posted September 17, 2023 On 9/11/2023 at 7:40 PM, MULEPACKHUNTER said: IF YOU BUY THE ACTION SIDE ILL SWAP IT AND KEEP THE WRENCH????? WRENCH = 50.00 PLUS SHIPPING Granted Howa is known to be the worst factory removal known to gunsmiths Where are you located? Share this post Link to post Share on other sites
MULEPACKHUNTER Report post Posted September 17, 2023 WICKENBURG Share this post Link to post Share on other sites
