Jazz Report post Posted April 4, 2022 Not straightforward. Maybe it's just me. Wife (AKA Elkslayer) is shooting a Matthews Avail at 40lbs (ATM), and about 233 FPS. We did all the calibration stuff. (5 pin). Used the top pin. When calibrating to 60, the sight housing went so low the fletchings would hit. The plan: Get her to 50lbs, (About 250fps) sight in all 5 pins normally, and use the wheel for 60+ shots and calibrate with the bottom pin. Does that sound right? Share this post Link to post Share on other sites
Noworries Report post Posted April 4, 2022 You’ve got it. That’s how I do it on my multi pin sliders. Gives you the most range of motion. 1 Share this post Link to post Share on other sites
jdown Report post Posted April 4, 2022 I know easier said than done but if she can lower her anchor point comfortably - even if she can get use to a kisser - might be able to raise that sight bracket and still get the yardage you are looking for. If that continues to be a problem for her. 1 Share this post Link to post Share on other sites
creed Report post Posted April 4, 2022 4 hours ago, jdown said: I know easier said than done but if she can lower her anchor point comfortably - even if she can get use to a kisser - might be able to raise that sight bracket and still get the yardage you are looking for. If that continues to be a problem for her. ^^^^^ This Small adjustments with a peep can change POI. Good luck with the slider. I will never use one again. Share this post Link to post Share on other sites
PatrickJr Report post Posted April 5, 2022 Also make sure to put the 60yard pin as low in the housing as possible, this will give her the greatest clearance when dialing. Share this post Link to post Share on other sites
Jazz Report post Posted April 5, 2022 4 hours ago, PatrickJr said: Also make sure to put the 60yard pin as low in the housing as possible, this will give her the greatest clearance when dialing. Good stuff. Thanks. 1 Share this post Link to post Share on other sites
