Search the Community

This is the boat I picked up from a member on here . It leaked in the bottom seam. Trailer had wires chewed up. I rewired the trailer . Put new running boards on the trailer. Cleaned and repacked the bearings,and installed buddy bearings. Applied 4 coats of white flex seal on inside and out. And 4 coats red flex seal to all areas in red. Then 4 coats of clear on the entire boat. Wanted to deck the back in . But if I did and then installed a seat . I wouldn't be able to work the till motor, I would sit up to high. I did deck in the front. And plan on installing a trolling motor platform at the very front bow . And a bow mounted trolling motor. The deck is covered with white flex seal,with a cotton membrane in needed in-between 3 more coats of white. Then 1 coat of red with silica sand dusted on top. After drying . I blew the excess sand off and coated with a coat of red and two coats of clear. I personally will give it a lifetime warranty on leaks . Not going to happen. Unless you run it up in rocks. Has a 5 .5 horse Johnson Evenrude on it . Still have a little work left to go. But definitely will be floating in San Carlos lake this weekend. 😁