ctafoya

Mesa?

Price, garage specs, will it fit a RZR 4?

I think I have a box. I wont be home till this weekend. I'll check then and let you know.

Next will be a bonus point for proof of vaccination

Cheapest newer truck in town!

I gotta get the darn thing set up first! been sitting in the corner of my reloading room since I got it. No time for anything these days.

I'm looking at getting a dillon 550c with some upgrades and dies for 223. I have several thousand to load. Do you think it's worth it over a single stage? Are there any issues with consistency when mass reloading with these?

Still looking for my first with my bow. One of these days...

Mercy kill.

rating on the lift?

Next year. I am always too busy this time of year to get out. I need to change my priorities.

Colman stove. Seems to flood out at higher elevations. I dont have time to mess with it. Served me well for several years. About 1/3 full can of fuel. $30. Must pick up in east mesa.

I wish I was ready/able to slow it down.

.

Got a new bow so this one needs to go. Comes with stabilizer, quiver, case(lost keys), and some arrows. The finish is getting sticky for some reason. I tried a few different cleaners to try and make it not sticky, but no luck so far. I'm not sure what the deal is with it. Draw is 29. Comes with two extra modules, I think for 28 and 30. Will need some attention regarding the strings. $300. East valley.

ttt

TTT

Duplicates I don't need. Must pick up in east mesa. Old style dewalt 18 volt right angle drill, Sawzall, and circular saw. One battery that's holds enough charge to test the tools. If you have batteries your good to go. $50 Dewalt grinder. Cord is shot but it works.GONE Makita grinder new in box. GONE Dewalt 1/2" impact. Works great. $30. Bosch driver. Two batteries. Very little use $50. GONE Ryobi sander. $5 Milwaukee Sawzall GONE Ryobi jig saw. $30.

TTT

Bunch of old tins. $15. Pickup in east mesa.

gone

Hole saw kit is $15.

Grinders and Milwaukee saw pending pickup.

My kids 96 1500 is sick. Throwing a p0300 random misfire code. Fuel pressure is 60 PSI. Plugs look like it's running lean. It has 215k miles so I'll probably replace them, wires and cap. PCV is good and I have good vacuum. Sprayed carb cleaner everywhere and couldn't find any leaks. Any other ideas before I pull the intake and replace the spider assembly?

Plugs, wires, cap and rotor. Purring like a kitten. Got lucky this go around. Thanks for everyone sharing thier knowledge. It's been too long since I've dusted the tools off.