Hoofnit

You can rent them from CH4d reamer rentals pretty cheap 🤷🏼‍♂️

Up

Springfield M1A / M14 VLTOR SOCOM II hand guard / rail system $150 OBO.

No it’s gone

For sale or trade a Ruger 10/22 Deluxe with a Leupold 2 X 7 rimfire scope, bought this years ago to teach my daughter how to use a scoped rifle and it’s sat in the safe since. $400 OBO Christmas is coming 🎅🏼

Early Sig 229 in 40 S&W, box & 2 magazines. NOW 💥 $500 (💥$475 for a veteran 💥) OBO or trade for other firearms, Ruger single actions, S&W revolvers, Mauser based rifles, etc. This is a well made pistol, never got into the 40 cal (reloading) so it’s just sat in the safe for a while, like to turn it into something else.

Man that thing is really putting you through the wringer! I would suggest you take it to a reliable gunsmith and have the headspace checked & at that point you could run a reamer in the barrel to clean it up… if you’re handy enough you can rent the headspace gauges and reamer + an extension for less than $100 all told from ch4d reamer rentals. Hope this helps, Mark

Tried to send you a pm but says you can’t receive them, what are you looking for? You should be able to send me your contact info through pm

That’s really cool!

Up with price change

Sold pending funds

^ up

Aluminum frame, Titanium cylinder, +P rated, 🤷‍♂️

So a couple things, first what press are you using? it will be harder to get your brass sized completely without a strong "O" frame press (think RCBS Rockchucker). Second what case lube are you using, like a lot of stuff lube matters 😉 (imperial sizing wax is best but there are others). Third is it the body of the cartridge that's too big or is the shoulder not getting bumped back? color the neck and shoulder first with a sharpie (I like black) and cycle it through the chamber and see if it's contacting, if not then try the body (this is the only place a small base sizer will help). Fourth, when setting your sizer die up are you running the press ram all the way up and setting the die against it? Some case / die / press combinations require that the sizing die be preloaded a bit (like a quarter to a half turn of the die past contact with the ram) to effectively cause the ram to cam over slightly, this will preload the frame usually resulting in the die to contact the shell holder during sizing. Fifth, head space on modern cartridges is a relatively small tolerance ( usually .003 to .006") so so grinding down a die or shell holder can easily cause excess headspace, a separated case due to excessive headspace is a bad experience! Hope this helps

PTG will have what you want,

👆🏼My IQ dropped by just reading this…

👆That’s freaking hilarious!🤣

There's something you don't see every day !😎

That is a P17 Enfield action not a Mauser, made in the US during WW1 by various contractors & sold by Remington as the model 30 for a few years until parts ran out. Good luck with your sale 😁

I’m interested, you can’t receive messages, pm me mark

You should absolutely start a go fund me page for them … cancer SUCKS!!!

I'll take this if you'll mail it to me

I'll take the hornet bullets

The action alone is worth 2 or 3 times (in that caliber the barrel may very well be toast as others have said) what you paid for the rifle, the action is already opened up for 375 H&H length cartridges...

Yes