Couzer

Agree, I load 90 grns in my 700 with a Custom Hart barrel.

GO DEVILS

Great caller, limited on volume, but sometimes you don't need the extra high volume

+ 1 good load data for a factory rem 700. Set the bullet to the internal mag.

Great job to all!!!!

Cool shayne! Post some pics when you get it rolling! I was very very happy with hart on my last rifle. Are you going to do any certain fluting on the barrel? Pooter your pretty funny! Although that would stink if that really happened! Your going to be jealous when I knock some coyotes tomorrow with the 25 wssm!

Careful not to put to much on the outside, it doesn't take much. One thing that has helped me is to lube the inside of the brass where the bullet is seated. I have had a few stuck cases, but eliminated this when I started lubing the inside. I use brake cleaner to clean the lube off. I've only had problems with the large caliber rounds. Hopefully this helps.

For me it's the gas money!!!!

I drew the same tag

Thanks guys for your comments! John my buck had a big ol body, I couldn’t believe how much meat I got off him, defiantly a lot bigger than my brothers. For as the rifles used, mine was a Custom Hart 300 RUM on a Remington action, the 210 vld did a great job. I did the gutless method when getting the meat off so I didn’t get a chance to recover the bullet. Only one small hole, and no exit at 225 yards. My brother took his buck with a 7mm Tikka T3 Lite. It was hard to believe his buck was in that steep canyon, if you click on the picture to blow it up, you can barely make Scott out in the picture. Clint, great job on your buck to!!!! To bad we didn't run into each other.

Red Ryder teaches the kids early how to use Iron Sights.

Red Ryder for sure! That's if they make them.

Jackrabbit and cottontail

Sweet barrel

Post the pic so we can help identify the low life scum

Great write up, it's like I was right there feeling your pain!!!! Great job!!!

Holy eye guards!!! Great buck and bear!!!!

Show some pics of that 128 toad! That's awesome!!!! If you have any!!

Nice job! Way to stick with it and finding him!

I saw 4 bulls of the 87 south of Mt ord in August. Pretty low and crazy!

Nice job!!!!! Congrats

Looks like you need a hunting buddy, where do I sign up? Ha ha good job Jeff. Is that a cz, if so what caliber? Awesome job

Nice job! I have been there on using a box of shells! Nice finds as well.

Right now it is has about a .470 diameter +/-, so he will have to open it up to accommodate the Wsm about .540 +/-. I don't have the exact measurements. A sako extractor will have to be installed as well. Also notching the bottom receiver is probably going to have to be done so the long BC bullets will feed properly. When he throats it, I have asked that to leave it a little short so I can play with the seating depth.

Just dropped the the rifle off at the gunsmith in Mesa today. Looks like I'll have back by Jan 1st. David I found a mag from RWS gunsmithing . It is a 7 round mag for the WSM cartridge, thanks for letting me know about the new law about the more than 5 capacity. Also I should have a suppressor by Jan if all goes well with the Feds.