bowhunter-tw

Ttt

Seems to be in very good condition for a gun of its age. Comes with remington 1917 bayonet located in tempe $1000

Ttt

30-06 dies rcbs spoken for? If not I’ll take them

Anybody have the tools to cut a crown with barrel installed? (I could pull the barrel if its easier) I have an ar set up for coyote that has a very poor crown if any. It probably doesnt matter for an ar, but id like to clean it up if I could.

Only words I can find stamped are “Helicodog” and “Bayonne and Barthe” Really struggling to find similar to for value. $2000 OBO

Thanks for the info! I will do some more research off of that!

I’d be interested in some 20ga if op is not or has found shells elsewhere.

Interested. You cant receive pms currently.

If there was another one of these on here at all I would be very surprised. I have searched and searched and cannot find anything identical.

Still up, price drop $500

Still up, price drop $1000 w bayonet

New to loading a belted magnum cartridge, though that might not matter. I noticed the bolt requires a decent bit of force to rotate and lock the lugs when a reloaded cartridge is placed in the chamber. There are no rifling marks on the bullet so I know (think) my seating depth is ok. Is it possible I am not bumping the shoulders back far enough? How would I confirm?

I will keep an eye on them after I fire them in my chamber. I need to learn to anneal also.

Ok, so I bumped the shoulders back and they chamber. Now what is throwing me off is that without changing the setting on the die some of the cases bumped farther, some bumped less, and most of them bumped to nominal right where I wanted them. What about the brass would cause this variance?

Is it a laminate stock or “real wood”? Also whats it weigh?

Would like to get this one sold. Make an offer??

Still available

Ive got a decent bit of 30-06 once fired. Id sell it .50cents each. Im in tempe

Anybody have one to sell?

Ok, I’ll bump them all. How do you get your die set to bump exactly .001-.002 thou? Just by un threading measure and threading the die down very little amounts each time then re measure?

I will put a little grease/lube on the lugs, I may pull the 10 loads I did just to be safe, if I can find a .284 collet. then re size to bump the shoulders 5 thou more. Any issue firing a case with dented shoulder? Had a little to much lube in sizing and it dented the shoulder in a few places, I imagine it would just fire form to the chamber when fired?

Its an older browning A bolt stainless

Full length, not fired in this gun. Headspace gauge read 2.120 bumped them back to 2.115 and the bolt closes easy now. New question, those cartridges that are bumped to 2.120 and close tight should I pull them and bump them to 2.115 or are they ok to fire?

I have them trimmed to ~2.49 after resizing.